Replacement of alkali silicate solution with silica fume in metakaolin-based geopolymers

Replacement of alkali silicate solution with silica fume in metakaolin-based geopolymers

论文摘要

A metakaolin(Mk)-based geopolymer cement from Tunisian Mk mixed with different amounts of silica fume(SiO2/Al2O3 molar ratio varying between 3.61 and 4.09) and sodium hydroxide(10M) and without any alkali silicate solution, is developed in this work. After the samples were cured at room temperature under air for 28 d, they were analyzed by X-ray diffraction(XRD), Fourier transform infrared(FTIR) spectroscopy, environmental scanning electron microscopy, mercury intrusion porosimetry, 27Al and 29Si nuclear magnetic resonance(NMR) spectroscopy, and compression testing to establish the relationship between microstructure and compressive strength. The XRD, FTIR, and 27Al and 29Si NMR analyses showed that the use of silica fume instead of alkali silicate solutions was feasible for manufacturing geopolymer cement. The Mk-based geopolymer with a silica fume content of 6 wt%(compared with those with 2% and 10%), corresponding to an SiO2/Al2O3 molar ratio of 3.84, resulted in the highest compressive strength, which was explained on the basis of its high compactness with the smallest porosity. Silica fume improved the compressive strength by filling interstitial voids of the microstructure because of its fine particle size. In addition, an increase in the SiO2/Al2O3 molar ratio, which is controlled by the addition of silica fume, to 4.09 led to a geopolymer with low compressive strength, accompanied by microstructures with high porosity. This high porosity, which is responsible for weaknesses in the specimen, is related to the amount of unreacted silica fume.

论文目录

  • 1. Introduction
  • 2. Experimental
  •   2.1. Materials
  •   2.2. Sample preparation
  •   2.3. Testing methods
  • 3. Results and discussion
  •   3.1. Mineralogical characterization of geopolymers
  •     3.1.1. Thermal analysis
  •     3.1.2. XRD analysis
  •     3.1.3. FTIR analysis
  •     3.1.4. NMR measurements
  •   3.2. Physical characterization of SF-geopolymers
  •     3.2.1. Compressive strength
  •     3.2.2. SEM observation
  •     3.2.3. MIP analysis
  • 4. Conclusions
  • 文章来源

    类型: 期刊论文

    作者: Ahmed Nmiri,Myriam Duc,Noureddine Hamdi,Oumaya Yazoghli-Marzouk,Ezzeddine Srasra

    来源: International Journal of Minerals Metallurgy and Materials 2019年05期

    年度: 2019

    分类: 工程科技Ⅱ辑,工程科技Ⅰ辑

    专业: 无机化工

    单位: Department of Chemistry, Faculty of Sciences of Tunis, University of Tunis El-Manar

    分类号: TQ172.4

    页码: 555-564

    总页数: 10

    文件大小: 380K

    下载量: 25

    相关论文文献

    • [1].The effects of long-term exposure to silica dust on serum CC16 and KL-6 levels[J]. China Medical Abstracts(Internal Medicine) 2019(04)
    • [2].Three-level all-fiber laser at 915 nm based on polarization-maintaining Nd~(3+)-doped silica fiber[J]. Chinese Optics Letters 2020(01)
    • [3].Raman scattering enhancement characteristic of NbCl_5-and Nb_20_5-doped silica fibers[J]. Chinese Optics Letters 2016(10)
    • [4].Mesoporous silica as micro/nano-carrier: From passive to active cargo delivery, a mini review[J]. Journal of Materials Science & Technology 2017(10)
    • [5].Therapeutic effect of miR-489 in a mouse model of silica-induced mature pulmonary fibrosis[J]. China Medical Abstracts(Internal Medicine) 2017(03)
    • [6].The effect of SiO_2 particle size on iron based F–T synthesis catalysts[J]. Chinese Journal of Chemical Engineering 2016(07)
    • [7].Radiation-pressure-driven mechanical oscillations in silica microdisk resonators on chip[J]. Science China(Physics,Mechanics & Astronomy) 2015(05)
    • [8].Atomistic study on tensile fracture of densified silica glass and its dependence on strain rate[J]. Chinese Physics B 2020(12)
    • [9].Mechanical and microstructural response of densified silica glass under uniaxial compression:Atomistic simulations[J]. Chinese Physics B 2020(10)
    • [10].Preparation of hydrophobic hierarchical pore carbon–silica composite and its adsorption performance toward volatile organic compounds[J]. Journal of Environmental Sciences 2020(01)
    • [11].Durable superamphiphobic silica aerogel surfaces for the culture of 3D cellular spheroids[J]. National Science Review 2019(06)
    • [12].Evaluating the potential of surface-modified silica nanoparticles using internal olefin sulfonate for enhanced oil recovery[J]. Petroleum Science 2020(03)
    • [13].Recent developments in novel silica-based optical fibers[J]. Frontiers of Information Technology & Electronic Engineering 2019(04)
    • [14].Experimental investigation of enhancement of carbon dioxide foam stability, pore plugging, and oil recovery in the presence of silica nanoparticles[J]. Petroleum Science 2019(02)
    • [15].Effect of removing silica in rice husk for the preparation of activated carbon for supercapacitor applications[J]. Chinese Chemical Letters 2019(06)
    • [16].Preparation of water-soluble magnetic nanoparticles with controllable silica coating[J]. Chinese Journal of Chemical Engineering 2018(01)
    • [17].Modification and investigation of silica particles as a foam stabilizer[J]. International Journal of Minerals Metallurgy and Materials 2017(02)
    • [18].Synthesis of ZSM-5 with the silica source from industrial hexafluorosilicic acid as transalkylation catalyst[J]. Chinese Journal of Chemical Engineering 2017(09)
    • [19].A novel method to anchor methanesulfonic acid in silica matrix[J]. Science China(Chemistry) 2016(03)
    • [20].Sol-gel preparation of a silica antireflective coating with enhanced hydrophobicity and optical stability in vacuum[J]. Chinese Optics Letters 2014(07)
    • [21].Selective removal of heavy metal ions from aqueous solutions with surface functionalized silica nanoparticles by different functional groups[J]. Journal of Central South University 2014(09)
    • [22].A theoretical model of thulium-doped silica fiber's ASE in the 1900 nm waveband[J]. Optoelectronics Letters 2010(01)
    • [23].Study of Pickering emulsions stabilized by mixed particles of silica and calcite[J]. Particuology 2010(04)
    • [24].Synthesis and separation performance of silicalite-1 membranes on silica tubes[J]. Science in China(Series B:Chemistry) 2009(05)
    • [25].Waveguiding properties and applications of silica nanowires in various environments[J]. Optoelectronics Letters 2009(04)
    • [26].Biogenic silica in surficial sediments of Prydz Bay,Antarctica[J]. Chinese Journal of Polar Science 2008(01)
    • [27].Characteristics of optical emission during laser-induced damage events of fused silica[J]. Chinese Optics Letters 2019(12)
    • [28].Operational Laboratory Methods for GDGTs Groups Separation[J]. Journal of Ocean University of China 2020(05)
    • [29].Solution-processable precursor route for fabricating ultrathin silica film for high performance and low voltage organic transistors[J]. Chinese Chemical Letters 2017(11)
    • [30].Novel one-pot synthesis of 4H-chromene derivatives using amino functionalized silica gel catalyst[J]. Chinese Chemical Letters 2014(03)
    Replacement of alkali silicate solution with silica fume in metakaolin-based geopolymers
    下载Doc文档

    猜你喜欢